Replacing RAM on laptop! (DIY)
Hello everyone, yesterday i meet @tommyl33 to hand over his laptop.
which I used to make this tutorial.
https://www.proofofbrain.io/hive-150329/@tawadak24/how-to-replace-laptop-hard-drive-hp-14-am036tx
So after I finished my work in studio. I meet him at a restaurant nearby.
This is how the place looks like now. Before, this place was always filled with people, but now only few people will go and eat at this place because of the pandemic.
Some of the shop nearby was closed because of the pandemic. I am grateful because I still can do my job at the studio on this area.
So this is the laptop, and you can see on top of it a new RAM for upgrade. This was quick upgrade for the laptop. Luckily I always bring my tools in my backpack.
Fast forward.
The cover of the laptop had been removed. If you guys want to know how to remove the laptop's cover. I have its tutorial Here
I am using this RAM from SEMSOTAI - 4GB DDR3 1600 which is the same speed of the original RAM in the laptop. The laptop original RAM is 4GB. Now I will upgrade it to 8GB. XD
RAM was removed from its box, and you can see from the picture above, the RAM slot and the new RAM is compatible.
Now to install the new RAM. just place it on the slot and make sure it is not upside down, by adjusting the RAM cut out to match the RAM slot cut out.
Nos just press it down until the clip lock at both side of the ram is placed properly beside the RAM and make sure the RAM is not moving after installation.
Just make sure this both clip on the side (red box) is placed on its place and you are good to go.
Now the installation of new RAM is finished. Now its time to put back the cover and check if the new RAM is installed properly.
As you can see , the details of RAM
Total memory slots : 2
Used memory slots : 2
Free memory slots :0
Memory size 8192 MBytes.
Both memory slots is used and the RAM had been upgraded to 8GB.
Now I am happy and @tommyl33 is happy for its new upgrade. :D
I have never seen the inside of a laptop and this is very complicated, not sure how you keep track of these screws as the are tiny.
the whole tutorial looks good and i liked the pictures. Thanks a lot for sharing these.
!LUV 1
you are most welcome @harpreetjanda :D i am glad you like it :DD
Hi @tawadak24, you were just shared some LUV thanks to @harpreetjanda. Holding 10 LUV in your wallet enables you to give up to 3 LUV per day, for free. See the LUV in your wallet at https://hive-engine.com or learn about LUV at https://peakd.com/@luvshares
Congratulations @tawadak24! You have completed the following achievement on the Hive blockchain and have been rewarded with new badge(s) :
Your next target is to reach 800 upvotes.
Your next target is to reach 100 replies.
You can view your badges on your board and compare yourself to others in the Ranking
If you no longer want to receive notifications, reply to this comment with the word
STOP
Support the HiveBuzz project. Vote for our proposal!